Today was fairly limited in what we could do, owing to forgetting to bring the U-bolt to tighten up the exhaust manifold to downpipe connection.  However, I did manage to finally fit the new driver’s seat!

ralph drilling seat brackers

And here it is in position…

new seat all installed

Did some other bits and bobs.  Cleaned off the knackered seal on the scuttle panel.  At some point I’ll apply a few beads of Sikaflex on this before we pop it back on, to give her a better seal on the bottom of the windscreen.

scraping old sealant off scuttle panel

We had a good opportunity to look at all the rust that needs treating and holes that need filling.  Next time we’re putting in a stereo and sound system, so we’ll have some tunes to fix up the bodywork to!

Share